10″ Panel Saw with Sliding Beam

Product Description

DISCONTINUED APRIL 2020

This item is no longer available to order. A limited range of spare parts are still available. Contact our sales office to order.
Any accessories listed in the ‘Related Products’ section below, are still available to order online. 

Panel saw with 48” Sliding beam.

• 3hp Induction Motor with Brake
• Cast Iron table saw
• 4 Travel Sliding Beam
• Rip Fence with Micro Adjuster
• All Extension Tables Included
• Mitre Fence Included

Based on our best selling 10″ Table Saw, we have increased the specification by adding a more powerful motor and a sliding beam with a 1220mm length of cut. This makes the saw ideal for handling large panels, anything up to an 8 x 4 sheet.

The sliding beam of this table saw, runs on a set of bearings along a sturdy support bed with additional support legs at each end. This gives a very smooth action with a high degree of accuracy. The beam can be locked in position when using the rip fence.

The extension table is also supported by a telescopic arm to take the weight of larger panels. The squaring arm at the rear of the table can be adjusted at any angle up to 45 degrees and is fitted with a flip over stop for repeat measurements.

For crosscutting smaller pieces we also provide a mitre fence which locks onto the sliding beam and can be adjusted to any angle from 90 to 45 degrees.

Supplied with 36 tooth TCT sawblade, push stick, rip fence, 1.8m power cable and UK 3 pin plug.

W660 Specification

Please note: It is not possible to use a stacked dado set with this saw.