V3FJ10 Bowl Reversing Jaws 10″ Diameter for Viper3 Chuck
V3FJ10 Bowl Reversing Jaws 10" Diameter for Viper3 Chuck
Dimensions for V3FJ10 Bowl Reversing Jaws 10″ Diameter
Dimensions for V3FJ10 Bowl Reversing Jaws 10" Diameter
Viper Woodturning Chucks
Viper Woodturning Chucks
V3FJ10 Bowl Reversing Jaws 10" Diameter for Viper3 Chuck
Dimensions for V3FJ10 Bowl Reversing Jaws 10" Diameter
Viper Woodturning Chucks
PngItem_1279117

Downloads:

Charnwood V3FJ10 Bowl Reversing Jaws 10″ Diameter for Viper3 Chuck

Product Code:V3FJ10
Barcode: 5060281697677
(2 customer reviews)

£45.00 (£37.50 Excl. VAT)

In stock

Bowl Reversing Jaws 10″ Diameter for Viper3 Chuck.

Bowl reversing jaws, also known as Cole jaws or Flat jaws are most commonly used for remounting finished bowls to re-shape the outside or to remove unwanted spigots, recesses or jaw marks.

The outside edge of the jaws are 210mm diameter when closed, 245mm diameter when opened. The work piece is held in place by 8 rubber coated fixings. They can be fitted in 7 different positions, in 12mm intervals, depending on the diameter required. A chuck with minimum Jaw travel of 24mm is therefore required to use these jaws.

For bowl diameters from 47mm up to 225mm.
Please note max. rpm 600.

Supplied with 2 sets of rubber coated fixings;

8 x 10mm diameter x 17mm long
8 x 10mm diameter x 13mm long

Jaws for the Viper3 are compatible with the following chucks:

  • Charnwood W836 (Requires V3JS jaw screw set)
  • Vicmark VM100 (Requires V3JS jaw screw set)
  • Record RP4000
  • Rutlands Dakota XT700
  • Warco 9405
  • Craft Supplies CS400
  • Fox FX4000
  • Versachuck (Requires VM100 Jaw Carriers)

2 reviews for Charnwood V3FJ10 Bowl Reversing Jaws 10″ Diameter for Viper3 Chuck

  1. Jim Scott –

    I am a new turner, so have made a few mistakes. Bought this to rescue a couple of bowls where my mortice was not up to standard or warping had occurred. I did consider making a donut chuck but for cost of materials and other bits was not much less than this. Works as expected, I would recommend wholeheartedly.

  2. George Newton –

    Bought these jaws so I could finish the bottom on a particularly difficult bowl to turn, they worked admirably although I did bring up the tail stock with a live centre. Used them on the lowest speed on my Record lathe, the bowl was turned into end grain using a section from an English Cherry Tree crotch, therefore it was not an easy turn, but the jaws worked perfectly without a moments concern. excellent addition to my Fox 4000 chuck

Add a review

Related Products

You may also like…